http://diylilcnc.org/forum/topic/pci-parallel-port-card Free, open-source plans for a low-cost 3-axis CNC mill by Taylor Hokanson and Chris Reilly. Sponsored by the School of the Art Institute of Chicago. en-US Wed, 08 Feb 2012 01:00:55 +0000 http://bbpress.org/?v=1.0.2 q http://diylilcnc.org/forum/search.php http://diylilcnc.org/forum/topic/pci-parallel-port-card#post-248 Tue, 09 Feb 2010 05:07:46 +0000 DIYengineer 248@http://diylilcnc.org/forum/ <p>I looked into the real time nature of the converters and as you said they are basically junk. I looked for a few hours and came back with nothing that seemed to operate in realtime. From what i have read, the convertors change the signal from digital (USB) to analog (serial/parallel). The time is takes to convert the signal is the problem. I think until hobbycnc creates a USB out board, everyone is going to be stuck with PCI/PCI express to parallel convertors, or onboard parallel ports. I've been looking at the reprap project and the use of the Arduino solves the problem and eliminate the parallel port all together; but for now picking up a old PC off craigslist for $10-$50 dollars is much more appealing lol. :) </p> http://diylilcnc.org/forum/topic/pci-parallel-port-card#post-237 Sat, 06 Feb 2010 18:24:47 +0000 Taylor 237@http://diylilcnc.org/forum/ <p>We went the old computer route, so I'm afraid there are no direct experiences to report on our end. If you're willing to spend $50 on the card, you might consider shelling out a little more for a parallel to USB converter box. Be aware that simple conversion won't do - the "real time" nature of the signal needs to be maintained. We've been trying to research this angle so that folks can work off of modern laptops, but haven't managed to source the correct part yet. Let us know if you decide to investigate this approach and we'll put our heads together. </p> http://diylilcnc.org/forum/topic/pci-parallel-port-card#post-232 Fri, 05 Feb 2010 07:17:40 +0000 DIYengineer 232@http://diylilcnc.org/forum/ <p>All the Pc's in my house are newer, which means i'm going to have to purchase a card from <a href="http://www.newegg.com" rel="nofollow">http://www.newegg.com</a>, Any one else using a PCI-Parallel card? Seems like the Good brand "Sig" ones are about $50 bucks, which is ridiculous but its old technology :( The Rosewill and Symba brands start out around $15 dollars, but have iffy reviews. Any one else in the same boat as me? </p>