DIYLILCNC

1. EqualsP
   Member

   While researching for other sources for the parts, I found that Monoprice.com is a cheaper source for the Wiring Harness $0.76 each for the 14, Product ID 1316.

   http://www.monoprice.com/products/product.asp?c_id=102&cp_id=10245&cs_id=1024501&p_id=1316&seq=1&format=2

   Posted 2 years ago #

2. DIYengineer
   Member

   You could always buy a spool of wire, the clips, and the plastic housing and DIY. I doubt it will be cheaper but the connections might turn out a bit more solid. After 2-3 disconnects on cheaper Pre-fab units the pins like to migrate out which is annoying but easily fixable. If you never or rarely disconnect them no worries.

   But .76 cents each is dirt cheap and tempting!

   Posted 2 years ago #

3. Taylor
   Key Master

   Also, keep in mind that the hobbycnc driver kit comes with a length of 6-conductor wire (at least it did when we purchased ours). This can be spliced with the jacks listed above to balance convenience and cost.

   Posted 2 years ago #

4. amigaman
   Member

   I found 36" cables here:

   http://www.pctoys.com/powerext.html

   for $1.95 with free shipping.

   Posted 2 years ago #

RSS feed for this topic

Reply

You must log in to post.