DIYLILCNC

1. bill
   Member

   Neat project. I can't see any mention of the software you're using to run the machine. If you're not already using it, I'd recommend EMC/Axis, available as open software at http://www.linuxcnc.org

   Posted 2 years ago #

2. Taylor
   Key Master

   Funny you should mention it, as EMC is our software of choice. We describe how EMC is used as our controller on pages 61-63 of the project instructions PDF (see Downloads section).

   Posted 2 years ago #

3. bill
   Member

   Excellent. I looked in the forum and various other places, but I didn't actually download the PDF, because I was under the impression it was just diagrams for cutting out parts. Looks like a pretty cool setup. I hope you have great success with it. :-)

   Posted 2 years ago #

4. Chris
   Key Master

   Please see complete software info in this post: http://diylilcnc.org/forum/topic/software-workflows

   Posted 1 year ago #

RSS feed for this topic

Topic Closed

This topic has been closed to new replies.